Support Center

Solo 8 Software Installation

Last Updated: Sep 12, 2017 02:04PM PDT

For Windows Users:

1. Make sure the USB cable is plugged into the "Install" port of the Solo 8.
2. Open My Computer, then click on the HoverCam Drive.
3. Choose Setup.exe then install HoverCam Flex VIEW and HoverCam CAP for Windows.
4. After installing each software one at a time, remove the USB cord from the "Install" port.
5. Plug the USB cable into the USB port located to the right of the "Install" port. This enables you to use the Solo 8 with the software.
6. Launch the software.

For MAC Users, open the HoverCam Drive on the Desktop and install the HoverCamFlex10.pkg file.


Submit a Ticket
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
Invalid characters found